Engine OBD Code

Ginetta G33 C0359 OBD Error

Intake Manifold Runner Control Malfunction (Stuck Open) The IMRC system is monitored for failure during continuous, key ON engine OFF or key ON engine running self-test. The test fails when the signal on the monitor pin is less than an expected calibrated range at closed throttle. IMRC monitor signal circuit shorted to PWR GND or SIG RTN Damaged IMRC actuator Damaged PCM An IMRCM PID reading approximately near 1 volt at closed throttle may indicate a fault.

C0359 Code Symptoms

Check Ginetta G33 C0359 trouble code with comparing symptoms

When you turn on the ignition, the Service Engine Soon or Check Engine C0359 Ginetta G33 light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If C0359 OBD/2 Ginetta G33 so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the C0359!

C0359 DTC For Ginetta G33

OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

Fixing Ways For C0359 Code:

C0359 OBD2 Code Removal Process

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C0359, so consult the manual to locate the brake fluid reservoir.

Bear in mind that a low fluid level can set code C0359 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.

C0358 Previous Engine OBD Code For Ginetta G33 Next Engine OBD Code For Ginetta G33 C0360

About Us - Contact - Privacy Policy

Copyright 2019 © EngineOBDCode.com - Engine OBD and OBD2 Code Check-Up Tool